avatar  


Recently viewed tickets

Log out

Setup Mac OSX for COM Wireless

SETUP MAC OSX FOR COM WIRELESS
These instructions apply to Apple Mac OSX Lion and greater. You will use a setup wizard called Cloudpath XpressConnect to connect your device. You may also use these instructions to recreate your connection in the future. This may be necessary if you delete your connection or change your password. Please note that the "COM_Limited" wireless is for onboarding purpose ONLY. You must complete your setup to join your assigned wireless network.
Step 1: Enable wireless on your device If your Wi-Fi is already enabled, go to Step 2. If disabled, follow below instructions.
Choose System Preferences from the Apple menu.
Choose Network from the View menu.
Then select Wi-Fi
Turn ON Wi-fi. The Status will change to ON
Follow the below link for troubleshooting your Wi-Fi
https://support.apple.com/en-us/HT202222




Step 2: Select COM_Limited Within your Wi-Fi settings, select COM_Limited from your list of available networks.
The wireless login page will open automatically. This may take few seconds.
If that does not work, open the Safari browser (other internet browsers may not work).
You should be directed to the wireless login page.
If you are not redirected automatically, go to https://byod.marin.edu.
The illustrations below show only Student configuration. Staff (Classified, Faculty, & Management) and Guest configurations are similar.
Select your appropriate network access: you may be either Guest, Student, or Staff.




Step 3: Terms and ConditionsOn the wireless login page:
Read carefully the Terms & Conditions of using COM wireless
Check I accept the terms of the End-User License Agreement, if you agreed.
Click Start.
Click OK at the notification prompt.

 

Step 4: Login credentials For the username, enter your MyCOM username (not your email address).
Enter your MyCOM password in the password field. Only passwords are case-sensitive.
Click Continue.



Step 5: Download CloudPath applicationDownload the file Cloudpath.zip




Step 6: Install the CloudPath application To start the installation
Open the file after downloading.


   Click on Cloupath file to launch the install
If you receive the pop-up notification that says, "XpressConnect cannot be opened because the identity of the developer cannot be confirmed,"
Click System Preferences.
Click Security and Privacy.
Click Open Anyway beside XpressConnect.
Click Open at the security prompt.


Continue through each of the subsequent installation steps.
Click on Update Settings to update Certificate Trust Settings


Click on Install Helper to install the new helper tool





Step 7: Complete the application installation Connect to your assigned wifi network (COM-Student, COM-Staff, COM_Visitor)


 
Creation date: 7/23/2018 9:58 AM (mjhoward)      Updated: 12/22/2020 1:46 PM (WLee)
Files   
DataImage12.png
31.1 KB resend
DataImage12.png
28.9 KB resend
DataImage12.png
36.9 KB resend
DataImage25.png
44.5 KB resend
DataImage28.png
43.4 KB resend
DataImage28.png
44.9 KB resend
DataImage41.png
27 KB resend
DataImage47.png
20.6 KB resend
DataImage77.jpg
27.3 KB resend
DataImage82.png
114.9 KB resend
DataImage91.png
15.8 KB resend
DataImage91.png
38.6 KB resend
DataImage91.png
22.2 KB resend